Thank you to our Sponsors
Here is the Beomaster 8000 that I acquired as part of an 8000 system earlier this year. I have been wanting to get this receiver working again but kept getting side-tracked. I think it is now time to dive into it. I have the service manual so I think I am set.
The first thing to figure out will be why the BM8000 always shows CLIPPING mode when it is turned on (STBY to any function). Tomorrow I will open the unit up and clean off the dust.
Here is the Beomaster 8000 that I acquired as part of an 8000 system earlier this year. I have been wanting to get this receiver working again but kept getting side-tracked. I think it is now time to dive into it. I have the service manual so I think I am set.
This will be a nice thread. Looking forward!
/***
So am I!
I have opened up the Beomaster 8000 to inspect what sort of work I have to do on it. Starting with the back, there is a fair amount of dust but I have seen a lot worse. Once I get it all open I will clean it up and see what capacitors I need. I have the original service manual and it will give me the values but I like to check what is actually on the boards.
Display Module - 8
Lower panel in service position
After some quick cleaning, here is the left Output Amplifier Module - 5
Here is the right Output Amplifier Module - 5
Preamplifier Module - 3
FM Module - 1
FM Interface Module - 2
You must be logged in as a BeoWorld member to post replies to forum threads.
Register to access the forums, reference material, and exclusive member benefits — including our monthly prize draw.
Become a Member