The Beocenter won't react to turntable commands if no record is sensed so maybe the record sensing is bad ?

Martin

Thanks Martin, I hadn't though of that one!

 How would I go about checking it?

 Simon

I don't think it is the record sensing. I have tried reseat the record etc.

I turned the power on at the plug this morning and the turntable started spinning and the record arm moved the stylus onto the record while the  unit was still on standby. I pressed PH and stylus lifted and the platter stopped turning. Further preses of PH just cause a loud 'pop' sound from inside the unit.

Anyone know what might be wrong?

Simon
 

Bump!

Anyone got any idea what this might be? I think I have eliminated record sensing as when I remove the record press the PH the display flashes and nothing happens, but when I replace the record the display doesn't flash and I get the audible 'pop' but the turntable/stylus doesn't move.

Simon

Hello

After the bump have you tried to do other operations? Does the unit accept other command like radio channel selection (from the buttons 1 to 6) or not?

Let us know

Bye

Eugenio
 

Thanks Eugenio

The unit is still workling perfectly in every respect except for the fact that the turntable no longer starts. It has had this problem intermittently for a while, but now it happens all the time.

Simon

please wait, I'll check the electric diagram

Hello

I have a one suggestion for You. It is possible that you have a electricity problem in DIN plug. For example check and clear the pins.

Tomasz 

Thanks to everyone for all your suggestions.

It's working again for now!

I turns out to be a mechanical problem.

I remember form years gone by that some turntables with belt drives need a helping hand to get started by pushing them gently round with a finger  on the label if the belt was on it's way out.

This turned out to need quite definite shove with the heel of my hand , but then it started and played OK. There is however a grinding noise from the turntable whenever it is turning that wasn't there before.

I am guessing that something needs lubricating (maybe some bearings needing some love and attention) but the only service documentation I can find is circuit  diagrams. Can anyone point me in the right direction towards what may need lubricating please?

Thanks

Simon