Thank you to our Sponsors
Hi,
Does anyone have a wiring diagram to take an existing Powerlink cable and wire it to an RCA pre-out on a non-B&O amplifier?
I believe that it will be possible to use the existing Powerlink cable with a preout connection.
I have the Powerlink v3 and also Powerlink that has RJ45 on one end. I will cut off the RJ45 and put an RCA on it.
Regards,
Brent.
Peter Pan's 1 Oct post here should give you everything that you need: /forum/imported-unmapped/peter-pans-hjemmebio---interface---tips-amp-tricks#post-2261539
You can omit the USB connector if you don't need to trigger the Beolabs (if that's what you are using) to switch on.
Location: Warwickshire, UK
My B&O Icons:
Hi Brent,
If you decide not to solder these yourself, I have completed cables available here:-
Location: The cable workshop, England
My B&O Icons:
I think I have enough info to be able to try with the existing powerlink cable and solder new RCA plugs on the end.
Green and Brown are the audio wires. pins 5 and 3 respectively.
Pin 2 is for the shield.
You must be logged in as a BeoWorld member to post replies to forum threads.
Register to access the forums, reference material, and exclusive member benefits — including our monthly prize draw.
Become a Member