Thank you to our Sponsors
Hi,
I'm beginning with MLGW.
After a full reset, tick on "enable MLGWprotocol over RS232".
With a terminal program when MLGW is powered on we see over RS232 the boot process.
After a while led is green. When sending with BEO4, for example CD, nothing appears on the RS232 !
Should I enable something else ?
(BS9000 MKI SW 2.21, MLGW 2.24 )
Thanks !
Are you using the web browser interface for programming the MLGW? It has it's own feature for monitoring the B&O data traffic.
You have to recognize the BS9000 as a "node" on the MLGW via the web interface.There are useful help files here:
Yes I'm using web browser.
Maybe I missed the assignment. I'll try again.
But I can't select BS9000 with "assign single product". Are listed only BV10,6 et BL3500...
it works! But not very useful . You get only sources (CD Tuner) and nothing else. I hope to get more trafic on ML.
Yes I'm using web browser.
Maybe I missed the assignment. I'll try again.
But I can't select BS9000 with "assign single product". Are listed only BV10,6 et BL3500...
It sounds like perhaps the MLGW has not been reset since the previous owner and still has the previous owner's configuration. You must put the MLGW into a mode to detect your BS9000, then you use a command on the BS9000 for it to be detected by the MLGW. The help files walk you through the process.
Did a all reset an repeated the assignment process
it works! But not very useful . You get only sources (CD Tuner) and nothing else. I hope to get more trafic on ML
Thanks beojeff
You must be logged in as a BeoWorld member to post replies to forum threads.
Register to access the forums, reference material, and exclusive member benefits — including our monthly prize draw.
Become a Member