You have to connect your MCL2AV to the MCL out of your Beomaster. Powerlink on MCL2AV is an output not input. Did you connect a power suplly to the MCL2AV?

Stefan

I understand what you're saying. That is exactly the way I connected it.

The MCL2AV gets its power from the MCL 2 P, but I don't get a standby light on the transceiver

Can you activate it by pressing the mute button?

Stefan

No

Can you describe how you set it up? Cables, Beomaster....?

If you have a BL 1000 press LINK - 2 -  STORE. Does the LED react?

Does the MCL2P you connected the MCL to work?

Stefan

Setup is cables from beomaster 5500 to the MCL 2 AV. Then powerlink to MCL 2 P.

Transceiver is connected. I don't see an LED at all. The green lead that gives power to the transceiver doesn't give any current.

Sorry, I don`t know what you mean by "the green lead that gives power...". 

I don`t think you will get the MCL2P activated by an MCL2AV. You will need a special PL cable with PIN 1 and 4 bridged.

Setup should be: BM5550 -> SPEAKER2 out -> MCL wire -> MCL2AV ( -> IR Transceiver) -> Beolab speaker

MCL2P has an LED which is red in standby and green when activated....(??)

Stefan

Is the MCL-2AV connected to mains? AFAIR it needs it on power supply.

It is connected to the MCL 2 P via a DC cable.