Thanks Beobuddy! Do you confirm that option should be set to 0?

I never tried option 0.

Normally it has to do with the optional ir-eye.

It responds to Link-PC/Vtap2e/VAux, when opt 4 is used.

So, option 0 will probably make the BM1 a kind of slave.

BTW, what I discovered is, that when you disconnect the ML cable from the BM1 and then enter the setup (settingsmenu) from the BM1.

Then after 2 seconds you can change the command where the BM1 has to respond to. Normally it is "PC".

But when you change it to V-Aux, then the BM1 can be used with older equipment which do not know the PC command.

DrDimitris wrote:

Thanks Beobuddy! Do you confirm that option should be set to 0?

I have a BeoSound Ouverture, two BeoLab 4000 and BeoLab 3500 one. I would  buy beomedia 1  to hear the music that is in my PC. Is the beomedia 1 ok for this function?

No, you can't, because your Ouverture isn't N.MUSIC compatible.

Thank for your reply. Can I use beomedia 1 with my tv panasonic 42 plasma or is it necessary B&O tv?

Yes, You could use Beomedia 1 with your Panasonic TV. But you have to use additional equipment. I personally like the minimalistic style of BeoMedia1 more than iTunes.

You cold make it work, with an additional IR-eye and a lintronic TT455-RT-238 box.Configure the BM1 as it is done with older B&O TVs which do not support the PC command. Connect video to the TV and audio to the A.Aux to the overture (the adapter should be available at your B&O shop). To make it work at the press of one key on your Beo4 you have to use the lintronic box. It's a little bit tricky, but can be solved. If it's worth, ist up to you.

hfat

hfat wrote:

You cold make it work, with an additional IR-eye and a lintronic TT455-RT-238 box.

I am not sure why you'd need the TT455 box. Just an external B&O IR Receiver and that should work. 

p.

You are right about the TT455.

If you dont't want to use BM1 by pressing a single button you can forget about the TT455.

In this case you would set the overture to A.Mode 1 and configure the BM1 to listen to V.Aux command.

You first press A.Aux to start Overture, then you start BM1 with V.AUx command.

hfat