You are right, you need a 3,5 mm jack to IR cable.

Check the supported boxes first and go from there.

Ralf

Thanks a lot!

Any idea where to buy? Anything specific?? On Ebay they Charge +/- 30€, not a bargain!?

Markus

Try our sponsor:

I use

If you are able to solder, than make it your own.

Buy an ir transmitter diode, nearly every type possible

a resistor 270 or 330 Ohm

3,5 mm Jack mono.

Solder the Anode to the inner  pin, the kathode to the outer pin with the resistor.

Thats all for 3 bucks.

If your box will have an ir extention port you can make an 'optical' cable for direct connection.

Technisat from Germany uses a simple TSOP 38Khz  receiver, the front ir port is still accessible.

I can post the correct connections, if needed.

Ralf

As mentioned above select the box in respect to the installed PUC table.

So you need not an extra update from your dealer.

Okay, this might be getting more tricky than expected ;o(

I checked connections - there I find set top box rather than PUC. The pieces listen there show besides some boxes for satelite, which I like to use, also Items for Cable..... All items seem quite old and I am Note sure, if that will work, as I assume, I am already at S2 at home and not sure, if these items listed arme DVBS- i seem to have that installed anyway in the TV.

Can I just buy a technisat s1 and be Lucky to controll via Beo4?

Thanks in Advance,

Hi,

a Technisat S1 can be controlled by Beo4 if you have TEC.DIGI or TEC. digicorder in your list, something like this with (TEC.), at least basic functions will work.

Ralf