Hello kai,

although I am not using the control outputs of the beosystem 4 I strongly believe that they will work the exact same way as in Beosystem 3. Probably you will need some adapters to match the serial cables you now have to the rj45 control sockets of the Beosystm 4 but other than that I believe it will be fine.

A few years ago, I posted on here detailed instructions for how to make a cable between a BeoSystem 4 to a Lintronic code converter to control a project and screen. If you can find it.

Hi 

 

Thanks for the reply I can see I can get some from bang and Olufsen the connection for screen control not so sure I will have a look at the other solution

kai wrote:

Hi 

 

Thanks for the reply I can see I can get some from bang and Olufsen the connection for screen control not so sure I will have a look at the other solution

I might have misunderstood. There are the connections for IR blasters for PUC control, but there are also the open collector connections for more advanced cinema control -- such as using relays for motorized projector screens and shades. I was referring to the latter. It was extremely difficult to get the pin schematics from B&O to create the proper cables for the open collector control. I'm using the open collector controls to trigger a Lintronic code converter to send out control for motorized screen and lights when entering CINEMA mode.

Hi jeff

 

That what i was looking at looking at it the linnteonic should work, have tried to email them a few times but no reply