Hold your horses!

I've done this without any dissassembling or cutting. I used a plastic pipe (in Swedish "VP-rör"). There are two types of VP, link and

Hi, they must have changed the design.

The cable now goes into the charger through a small hole on the back.

OK, then I would just cut the cable and use a "sockerbit" to reconnect it again in the wardrobe.

Yeah, propably the best thing to do. The leads might actually be soldered to the pins inside the charger.

I may be wrong on this one, but at some point the connection from the cable and into the power supply was indeed a plug... By using a bit of strength you could turn it 90 degrees counter-clockwise and pull it out of the power supply. I would estimate this plug to be approx. 8 mm in diameter.

I'm not sure if the charger still is made this way, but it is worth a try.

You are right! It is a plug. I never looked at the power supply end of the cable.´

Thank you both for your help.

/Peter