The MX contrast screen won't fit on an LX, and only the MX series can be hung up on a wall, though the same Unity 2 chassis is being used.

-Søren

ok too bad, i just have to keep looking for a lx screen then...

thx for the help

-jesper

maybe its possible i could take the screen from another lx6000, but how do i get it off? it looks like it have been glued on, should i use a heat gun?

Forget about attacking the glue! Perhaps the glass is glued to its frame, but that's not how you remove it.

First pull off the speaker frets; start carefully from the bottom, the next two clips are in the middle and then two more at the top.

Then you will find four (torx?) screws, two on each side, and they hold the screen in place. Leave one of the top screws last and be careful, the glass is heavy!

I can't find the spare part numbers in the service manuals we have on site so I could confirm this, but I believe the screen will be the same as in the older 28" LX models. Thus a broken LX2802 or similar might work as a donor as well.

thanks very much for a fine guide, that sounds pretty simple. there is actually a lx2802 that can be picked up for free, close to my home so i think i give that a try.

-jesper

The LX5500 screen will fit ... the LX280x will not :(