BS9000 Cleaning Required after cleaning

4 replies
P(
plumber77 (archived2)
Bronze
98 posts
Posted November 29, 2018 at 19:45 GMT
#2115016

Hi

I've read all over this and done my best with the unit.

Removed glass door and cleaned, both finger pins, behind the sledge all inside the machine where I can get and the laser with a cotton bud.

Still comes up with cleaning required, Is there anything else I've missed??

I've deactivated safety mode and the 'cleaning required' has disappeared. TM74

I presume it bypasses this with the safety mode off??

Is there a major issue with leaving it off apart from loosing fingers!!

Unit now works a dream.

 

Could there be simply a fault on the finger protection circuit.

 

Thanks in advance

Mark

BE
beosince
Bronze
340 posts
Posted November 29, 2018 at 20:05 GMT
#2115017

Have you cleaned the small prisms?

P(
plumber77 (archived2)
Bronze
98 posts
Posted November 29, 2018 at 20:07 GMT
#2115018

Hi

Cheers for the reply.

Yes that was the first thing I did.

 

Regards

 

SO
solderon29
Gold
1051 posts
Posted November 30, 2018 at 10:26 GMT
#2115019

I was fooled by one of these!!! You need to clean the transmitter and receiver "prism's" all around,not just the flat parts,and use spec's cleaner ideally,as any film left behind by other cleaner's will affect the operation too.

In a worst case of course,you may have a fault in the safety circuit,but this is rare.

Nick

or
BeoWorld Gold Membership card
Join BeoWorld

Register to access the forums, reference material, and exclusive member benefits — including our monthly prize draw.

Become a Member

December 2026 Prize Draw

Gold Members Only

As a Gold member you're automatically entered into our exclusive prize draw — your chance to win iconic Bang & Olufsen products. A unique benefit of BeoWorld Gold membership, every draw brings a new opportunity to win something special.

View Prize Go For Gold