Hi and welcome to Beoworld!

Normally I'd be one of the first to accept the challenge of 'blind' programming of a Beo4, but I think there are just too many variables:  You don't know the SW version of the Beo4 and you don't know what may already be in the LIST.

Unless someone can suggest an alternative way to connect the Apple TV to the BV7, then I think your best bet is to look for a new (second-hand) Beo4.  You could also use a BL1000 - simply press SHIFT then STORE to send the PC command.

I should have added, you could also fit a new screen to your Beo4 - see the handy guide here: 

Hi, I am using an Apple TV with my BV7 and programmed the TV to use the DTV command on the Beo4 for that. On older Beo4s this is the SAT button. This is possible in my BV7 as there are no modules fitted, so the DTV command is available. When you could get this working as well, you do not need a working screen on the Beo4.

Note that you will need to run the HDMI to DVI cable AND a cable for the audio signal. I use an HDMI audio extractor and feed stereo to the white/red connectors of the TV. See this thread also: /forum/general-discussion-and-questions/using-dvi-socket-on-a-beovision-7#post-2062006

Hope this helps!

Guy wrote:

I should have added, you could also fit a new screen to your Beo4 - see the handy guide here: link

I agree that a Beo4 with a dead screen is a bit sad!

Hi,

You can only assign DVI-I to DTV or V.MEM on a MKii (Type 9361)

On a MKi (type 9351) it can only be assigned to AV4 and the PC button.

I strongly suggest to get a new Beo4.