beosystem 4 - motorstand

2 replies
BE
beoandy
Bronze
355 posts
Posted February 3, 2020 at 19:48 GMT
#2133225

i plan to change the beosystem 3 on a beovision 9 to a beosystem 4.

powerlink adapter, the monitor and the ir/auto contrast wiring doesn’t seem to be the problem. (found the cabling in the service manual)

but the beovision 9/beosystem 3 has a old motorstand with 5 pins:

1 - GND (Yellow) 

2 - Turn L (Red)

3 - Turn R (Brown) 

4 - Pos (Black)

5 - +12 (Orange)

 

and the beosystem 4 has 4 pins with can-bus:

MicroFit 4-pin

Pin 1 - CANL_C Negative CAN bus signal

Pin 2 - GND_STAND Ground for stand

Pin 3 - CANH_C Positive CAN bus signal

Pin 4 - 12V_STAND_C 12V supply for standTMDS.

is there any chance to control the old stand of the bv9 with the 4 pin can-bus of the beosystem 4? a adapter? or maybe change the motor and control of the bv9 stand with motor/control of a newer stand (bv11)?

thanks beoandy

D(
dmacri (archived2)
Bronze
835 posts
Posted February 7, 2020 at 13:20 GMT
#2133226
It seems that they may be operating with different control standards. The new setup appears to be using CAN bus for control.
or
BeoWorld Gold Membership card
Join BeoWorld

Register to access the forums, reference material, and exclusive member benefits — including our monthly prize draw.

Become a Member

December 2026 Prize Draw

Gold Members Only

As a Gold member you're automatically entered into our exclusive prize draw — your chance to win iconic Bang & Olufsen products. A unique benefit of BeoWorld Gold membership, every draw brings a new opportunity to win something special.

View Prize Go For Gold