Beosystem 3 MK1 Supported video output.

3 replies
AR
Offline
AMRA RAMA
Bronze
Posted September 10, 2015 at 15:17 GMT
#2048105

Hello Friends,

I'm in the process to upgraded to Full HD  the panel (an Old  HD ready 1366x720p 42" Panasonic Plasma) hooked to  a Bosystem3 MARK 1 (DVI Display out) .

Reading Beosystem3 threads here and in the archived forums and also asking around some dealers , I'm still confused if the Beosystem3 is able to output Full HD (1980x1024p) signal. It's running 4.17a SW version (I know it's old) , but I have understood that starting from version SW version 3 the full HD was supported.

Any clues ?

Also if somebody has the BS3 system manual (SW version 3 or superior, you can read the software version on the front page of the manual) could you share what are you reading at the video output section around page 6.5 ?

Thanks a lot.

 

Frog
Offline
Frog
GoldFounder
Posted September 10, 2015 at 16:11 GMT
#2048106

I'm nowhere near the screen right now but if you go into the engineering section of the menu (iirc menu, red, go) go to the monitor section then choose non-B&O display and set the parameters to 1080i.

 

not sure that this is exactly correct, but should be close - was some years ago I did it!

 

regards

 

frog

AR
Offline
AMRA RAMA
Bronze
Posted September 10, 2015 at 16:36 GMT
#2048107

Thanks ! will try that out.

or
BeoWorld Gold Membership card
Join BeoWorld

Register to access the forums, reference material, and exclusive member benefits — including our monthly prize draw.

Become a Member

December 2026 Prize Draw

Gold Members Only

As a Gold member you're automatically entered into our exclusive prize draw — your chance to win iconic Bang & Olufsen products. A unique benefit of BeoWorld Gold membership, every draw brings a new opportunity to win something special.

View Prize Go For Gold