Hi All
Can someone please help me on how to wire up the BeoSound 5 Encore to my BeoLab 5's, while retaining the LINE IN connection I have to my Non B&O Amp.
At the moment my setup is as follows:
Onkyo AVR (Pre out) --> (LINE IN) Beolab 5
I want to utilise the Powerlink cable to connect the BeoSound 5 Encore to the BeoLab 5's. But because my BeoLab 5's are in Option 1, it does not pick up the BeoSound 5 Encore when connected via Powerlink.
BeoLab 5 Options
Option 0 (factory setup): Used if connected to a Bang & Olufsen audio (or video) system.
Option 1: Used if connected to a non-Bang & Olufsen system. You may have a Bang & Olufsen television in the same room, if you wish.
Option 4: Used if connected to a non-Bang & Olufsen system – and you have an extra Bang & Olufsen audio system in the same room.
Now from the above, it would seem that Option 4 would be the one i'm looking for, but it doesn't work in that mode either. The BeoSound 5 Encore only works in Option 0 when connected via Powerlink.
Reason I want to connect the BS5 Encore via Powerlink directly to the speakers, and not go through the amplifier, is because even though I have one of the top Onkyos (PR-SC5509), the sound quality differs massively, even though the BL5's are connected via Pre-Outs.
Any advice would be appreciated as my BS5 Encore is just sitting gathering dust at the moment because of this :(
Thanks