Thank you to our Sponsors
Hello to you all,
I'm new to this forum and this problem may have already been discussed, so apologies if you have already seen it.
The item seems to work correctly,(after re-soldering a dry joint and replacing the lamps), but it gets far too hot within minutes of use. The transistors on the base plate seem to be the culprits but I'm not sure of the cause.
Any suggestions would be gratefully received.
Thanks
Paul
The idle current has probably drifted. Adjustment is done as described in the service manual and in this post:
/forum/imported-unmapped/bm1200-adjusting-idle-current
Location: Netherlands
Thank you for your prompt reply, I will check as you have advised.
The trimmers will be bad from oxidation, often to the point of falling apart physically.
Replace the trimmers and adjust.
Martin
Thank you Martin for your reply,
Do you know where I can obtain the necessary parts for this repair?
Regards,
Paul.
Any good electronics component supplier will have them.
- Or me.
They are part of a quite comprehensive servicekit available for this model, containing new components for all
electrolytic capacitors, tantals, trimmers and lamps.
Martin
Hello Martin,
That's good news, do you have a website or can you tell me the cost of the trimmers and also the complete service kit?
Regards,
Paul.
PM or email me.
Martin
You must be logged in as a BeoWorld member to post replies to forum threads.
Register to access the forums, reference material, and exclusive member benefits — including our monthly prize draw.
Become a Member