Had the same, see this post

https://archivedforum2.beoworld.org/forums/t/42390.aspx

Thank you..am glad things worked out for you.

I had given up yesterday and switched of the unit and tried again this morning after 12 hrs..nothing connected ..same thing..the moment you apply power..green light starts blinking...

It seems like a PC with disk crashed..there is power but no software to boot the hardware.

Hope this doesn't turn into a expensive paperweight  :-(

You mentioned about the switch being bad - Was it the setup switch ?

 

dahiyas wrote:

You mentioned about the switch being bad - Was it the setup switch ?

I was referring to my network switch. The converter did not get a good internet connection or IP address appointed.

Did you try a different lan cable?

Got it. Yes, I have tried brand new CAT7 cable (tried to follow all requirements in the installation guide), setup a standalone network..

No luck.

Have written to Beocare..let's see what they come back with.

Thanks Pat..How much does the PCB cost ?

I assume that's the small PCB connected with two ribbon cables ?

There are only 2 pcb’s inside - pcb 04 psu and pcb 01 main board - the one with all of the sockets and connectors. The part itself £150 + vat, the faulty module has to be returned to B&O DK, otherwise price of the part will be £301 + vat. Labour cost on top of that.

Thanks Pat.

 

You’re welcome 🙂

I got a quote of 945 USD !! So looks like I have a expensive teacup coaster for now 😁

Would you happen to know the part no. ?

Thanks,