Any suggestion/comment before my Beolabs 200 blown up ???

😁 😁 😁

thanks

mauro

Thanks Leosgonewild.

I know I can use speakerlink.

My doubt is more specifically about the switch on the Pentas (Input level: I, II, III ?)...

ms

Thanks Leosgonewild.

I know I can use speakerlink.

My doubt is more specifically about the switch on the Pentas (Input level: I, II, III ?)...

ms

This is what you want.

Thanks Peter.

I've seen the table on my user manual.

What I firstly need to know (as you can see on n° 1 in my original post) is: according to that table, which is the right position of the switch for a Beomaster 7000 connected with Speakerlinks ?

mauro

Thanks DMacri !

Now, I've been using the BM 7000 connected via speakerlink to the Pentas with the input level switch on III (=no attenuation) for a couple of days , and I think the sound is terrific like never before.

My final questions are:

- Did anyone experience this setting? (position III with BM7000/6500 and speakerlink)

- Could this setting damage the Penta's Beolabs200 ?

The idea (doubt...) behind this last question is originated from the not-excessive power of the beomaster 7000, arguing that this position COULD infact be ideal to get full potential from the Beolabs, more than the recommended powerlink/speakerlink in position I (which could possibly be a sort of "too safe setting" for the peakers...). 

mauro

Hi Mauro,

Yes, I also prefer the sound of my Pentas in the III switch position (without attenuation), this seems to be a better sound regardless on which input socket is used (ie. Powerlink, Speakerlink or Line).  This won't cause any damage.

Kind regards, Steve.