Dear BeoWorld Members,
I am new to this forum and I wonder if you could support with my query .
I have a set of Beomaster 4400 combined with Beovox S45-2, and I have recently bought used Beogram 4004 to connect to the system, but it appears to have an issue - with what I believe is power supply.
At first, after connecting the setup, Beogram worked well. I had to disconnect the set due to refurbishment of the flat, but everything was kept secured and intact. After some time, I connected the set again and, unfortunately, the issue occured - slide transport started, but after about 1 second it froze (and light went down) - appearing that power supply connection is lost. Power supply is not delivered when the START button is pressed.
I have not attempted to open/repair Beogram yet as, I currently do not have the tools to do so.
I wonder if you are able to help advise if my assessement is correct, or perhaps direct me to the service centre in Denmark (I am aware of two)?
I was searching for some information on the forum, and if I have missed a
relevant topic I would appreciate if you could point me in that
direction.
Thank you!
