Hi,
I have a BeoCentre 8500 which has obviously seen a few repairs. Referring to the service manual page 2-5, I wonder if anyone could help please:
1. In the top hand corner, R43 is marked as 750 ohms, mine is 499 ohms. Is that a deliberate change by B&O, an error in the documentation, or a poor previous repair. It looks a genuine (original) resistor from the soldering and bending, and its probably not critical, but it bugs me.
2. Next to that resistor is marked a 60R100 NTC. Please could someone identify what 60R100 means so that I can source one of these NTC thermistors. On my board this has been replaced by a 220k ohm resistor (which I think is a bad previous repair given the orientation and soldering of the resistor).
Thanks.
Avram
