Hi,
we did disassemble the MX8000 and according to the manuel on PCB1 at A11 the J40 should be the one to get into the service menue (via service pin / bus ignore mode) but only a testpad is at this position. Any idea where the correct pin is to get into the menue?
Thanks a lot
Thank you to our Sponsors
MX8000 SW1.4 Serice Menu with hardware mod - where is J40
1 replies
Please Log In to Reply
You must be logged in as a BeoWorld member to post replies to forum threads.
or
Join BeoWorld
Register to access the forums, reference material, and exclusive member benefits — including our monthly prize draw.
Become a Member