Hi,
I had to dismount the tonearm to fix a broken piece of plastic but did not pay attention to the 5 wires which is soldered onto the small board.
How on earth do I make sure i solder them back on correctly?
I quess I cannot just connect them randomly.
Maybe one of you guys now how the 4 sockets are to be soldered?I should then be able to measure which wire is connected to which socket in the end where the stylus is connected.
Thank you to our Sponsors
RX-2 tonearm wirering
3 replies
Observing from the front and comparing to a clockface:
12 = L
3 = R
6 = LG
9 = RG
You will need to use an ohm meter to identify which wire is connected to which pin.
Thanks Mark :)
Please Log In to Reply
You must be logged in as a BeoWorld member to post replies to forum threads.
or
Join BeoWorld
Register to access the forums, reference material, and exclusive member benefits — including our monthly prize draw.
Become a Member