hi, recently found an original 5 pin din cable to get my 1000 connected to the beomaster. Everything seems to connect up fine, sound from the speakers when in radio fm mode, a little hum from the speakers as the volume is adjusted when in beogram mode, motor works at all speeds etc so all looking good however when I try to play anything there's nothing. Does this sound like an issue with the stylus or even if it's damaged should I be at least getting something? Seems to be no response at all from it
Thank you to our Sponsors
Beogram 1000 output
5 replies
Check the wires from stylus/tonearm to 5 pin din plug
Location: Mexico city
Retired
Printing machine technician
Restored various 1960-70 items
Rock and Roll music
Collecting Vinyl
Restored Jukebox Wurlitzer 1050
Printing machine technician
Restored various 1960-70 items
Rock and Roll music
Collecting Vinyl
Restored Jukebox Wurlitzer 1050
Seems after checking a few photos online that I have no short circuit plate. I'm guessing all 1000s should have one of these as it seems on closer inspection the wires don't seem to connect through din to stylus arm
That was for the RIAA - probably relatively simple to jury rig that.
My B&O Icons:
Mine was bridged, here my thread
Location: Mexico city
Retired
Printing machine technician
Restored various 1960-70 items
Rock and Roll music
Collecting Vinyl
Restored Jukebox Wurlitzer 1050
Printing machine technician
Restored various 1960-70 items
Rock and Roll music
Collecting Vinyl
Restored Jukebox Wurlitzer 1050
Please Log In to Reply
You must be logged in as a BeoWorld member to post replies to forum threads.
or
Join BeoWorld
Register to access the forums, reference material, and exclusive member benefits — including our monthly prize draw.
Become a Member