Hi
When lid close and hit the mecanical stop (horizontal stop) it makes a little short jump of 2 mm and then closes fully.
Everything else is fine.
I have replaced the blue cap. on the motorcontrol PCB 8 board to the right value, 68 uF but that was very bad. When lid opened fully it said a "krak, krak" sound.
Mounted the original (measured 20 uF) again and open function was fine (???)
Does anyone have a tip or advise about the short jump when closing ?
Br Jens
When lid close and hit the mecanical stop (horizontal stop) it makes a little short jump of 2 mm and then closes fully.
Everything else is fine.
I have replaced the blue cap. on the motorcontrol PCB 8 board to the right value, 68 uF but that was very bad. When lid opened fully it said a "krak, krak" sound.
Mounted the original (measured 20 uF) again and open function was fine (???)
Does anyone have a tip or advise about the short jump when closing ?
Br Jens
