Can you post some pictures to show what your are looking at?

Thanks,
sonavor

Thanks sonavor for your attention,

It will be a bit tricky, because I don't have the turntable behind me...🙁

Thanks sonavor for your attention,

It will be a bit tricky, because I don't have the turntable behind me...🙁

Sorry for this second post, I click twice instead of one...👍

What I would like to know is, is that common that the end of the inside bearing has a plastic with a tiny hole in the middle ? and if not do we have a replacement plastic parts like the BG8000 ?

I will try to take a picture of one of mine tonight. I have a Beogram 4002 type 5523 that I can get to and check.

-sonavor

Steveric wrote:

Hi Folks,

Look for advise right now about what the suppose looking at the inside of the ended bearing shaft, I noticed the axis of the sub platter as a strange shape and the inside ended bearing has a plastic that looks the same shape of the sub platter, the tiny hole on the plastic parts suppose to be there or suppose to be flat ? Stay tune for your comments...😮

 

This is absolutely normal. There is only one sintered bushing at the top and the bottom is self-centered with what you describe.

I found a Beogram 4002 Type 5503 that was easier to get to. Here are a couple of pictures of center hub.
#1

Here is another one.
#2

Thanks a lot sonar and charts, in my recollection it looks more or less the same, so now I'm more confident.😕

I will shoot some pictures, when I will be behind the turntable, that's for sure could help some folks who have in mind the same question.🙂