Sign in   |  Join   |  Help

Remove dust cover on 4002

rated by 0 users
Not Answered This post has 0 verified answers | 4 Replies | 1 Follower

GDUB
Not Ranked
11 Posts
OFFLINE
Bronze Member
GDUB posted on Thu, May 6 2021 10:53 PM

Hi All

apologies if this is a very basic question but I can’t seem to find an answer that isn’t about disassembly.

I have just acquired a 4002 and it needs some TLC on the dust cover to remove blemishes etc. I’m going to use Scratch X but want to remove the cover intact as the springs etc work perfectly so don’t see the need to disassemble the cover from the rear section, just want to remove it from the table.

is it just a case of undoing two screws under the rear? Then what? Pull back, lift off?

 

thanks for any assistance, I don’t want to get this wrong or break anything.

All Replies

GDUB
Not Ranked
11 Posts
OFFLINE
Bronze Member
GDUB replied on Fri, May 7 2021 12:19 AM

Solved. Easy.

beobutler
Not Ranked
1 Posts
OFFLINE
Bronze Member

I have this same issue, how did you go about solving removing the dusk cover?

Mark
Not Ranked
San Francisco
58 Posts
OFFLINE
Bronze Member
Mark replied on Thu, Aug 19 2021 11:43 PM

There are two screw in recesses in the back corners of the bottom. Loosening but not removing those will release a captive fastener that allows you to slide the cover off to the rear. Perform this with the cover fully open. 

Dillen
Top 10 Contributor
Copenhagen / Denmark
13,060 Posts
ONLINE
Founder
Moderator
Dillen replied on Fri, Aug 20 2021 9:09 AM

And adjust the cover back/forth/sideways when fitting it back.

Martin

Page 1 of 1 (5 items) | RSS
Beoworld Security Certificate

SSL