Reply To: BeoX remote question

#7219
sebbe.b
SILVER Member
  • Topics Started 1
  • Total Posts 8

Hey again!

I managed to change AV 2 to Decoder. Very easily accessible  via the Menu button. But I can’t figure out (even with the TVs manual) how to enable decoder?

What I tried was: 1. TV (button on remote), 2. LIST (button on remote), 3. V. SETUP shows on remove – i push Go. 4. TUNE shows on remove i Push Go.

Then I get this:

Tuner_menu

Not sure if I’m at the right place at all?  Can’t figure out how to change Dec to on anywho.

Any help is deeply appreciated. Thanks 😊🙏