Reply To: Beogram 4000 record detection issue

#6727
spassmaker
BRONZE Member
  • Topics Started 3
  • Total Posts 36

Hi Alf

As the bulb is measuring about 40 Ohm it should be OK.

Check 1 R 30 (15 OHM) and all tracing connections.

About Transistors which are measuring off board in a good state….

If I pull one of these little BC5XX Transistors out I always put a new one in, cost only 5 to 20 cent and you’re shure that the new one will work.

Had already a lot of them measuring good, but a HFE about 20 or 100, too low in that case.

Hope it will help a little bit.

Kind regards

Christian