Reply To: Beolab 5000 Type 5303

#4625
hcraig244
Beoworld Member
  • Topics Started 3
  • Total Posts 70

You need to take the top off, remove the screws holding the amp PC down….it’s on a hinge so will lift up and can be put into the service position which is vertical. This allows access to the power on bulb, its a push fit onto a tab and can ce carefully pulled backwards untill released, you can then unscrew the lamp and replace it…..make sure you use the propper voltage…I think its 60vdc

PA134348 (Copy)