7 November 2022 at 04:51
#25658
I’m refurbishing a pair of Beovox RL 60.2 – one of them had 3 pieces of moulding inside that were broken. They usually hold the screw, so trying to unscrew them would just turn the screw as if the thread was stripped… Fun! Fixed with polyurethane which was what I had available then and I recovered with a new fabric. I have the second one to do now…
I also have a Beomaster 8000 next, but with a hot right heatsink so I’m not in a hurry to get at it. Although I did crack it open to see its state and it doesn’t seem too bad overall.
Then a beogram 2000 low on my priorities, since I’ll need to purchase a cartridge to test further…