Sign in   |  Join   |  Help

Beolab 6000 - Line in not working

rated by 0 users
Not Answered This post has 0 verified answers | 2 Replies | 1 Follower

Rivenflush
Top 200 Contributor
Gothenburg
333 Posts
OFFLINE
Bronze Member
Rivenflush posted on Fri, May 18 2012 5:38 PM

Hello,

the "Line in" on one of my Beolab 6000 has stopped working, the power link is working fine though.

Has anyone else come across this problem, could it be a bad circuit board?

Best regards,

Riven

My B&O products: Beosound 9000, Beosound 2300, Beosound Century, Beolab 8000, Beolab 6000, Beolab 4000 x2, Beolab 3500, Beolab 2000, Beolab 10, Beolink Active x2, Beotime, Beo5 x2, Beo4, A9 keyring x2, LC2 dimmer x6 and growing....

All Replies

tournedos
Top 10 Contributor
Finland
7,356 Posts
OFFLINE
Gold Member
Moderator

Likely a bad solder at the phono socket, perhaps a faulty mode switch, but it could also be a component failure in the autostart circuitry. Impossible to say without inspecting, but I'm sure it can be repaired.

--mika

Rivenflush
Top 200 Contributor
Gothenburg
333 Posts
OFFLINE
Bronze Member

Ok, thought it was something like that. Will have to bring it in to my dealer to let him check it out.

My B&O products: Beosound 9000, Beosound 2300, Beosound Century, Beolab 8000, Beolab 6000, Beolab 4000 x2, Beolab 3500, Beolab 2000, Beolab 10, Beolink Active x2, Beotime, Beo5 x2, Beo4, A9 keyring x2, LC2 dimmer x6 and growing....

Page 1 of 1 (3 items) | RSS
Beoworld Security Certificate

SSL