Hi puck5862,

You need mark.2 (Fully Wired) Powerlink cable for your MCL2P.  You can find this via my sponsor link at the foot of the page if required.

If you are connecting a subwoofer to an AV7000, you can:-

1) Connect Beolab 2 directly to the AV7000

2) Connect a passive sub (eg. Beovox Cona) to the output of the MCL2P along with the RL6000's

3) Use a Powerlink to Amplifier Cable (see my link below for details) to connect a non-B&O active sub directly to a Powerlink output on the AV7000.

Hope this helps, please feel free to ask if you have any questions.

Best regards,

Steve.

Hi 

Sorry if I confuse anybody.

I use an AV7000 with mcl2p's both for front and back speakers (cx100) but don't use (full) powerlink mark2 cables. 

In fact I had to desolder a few wires in order for it to work (if I remember correctly pins 6,7,8). I tried the thin ones (mark 3? ) and they work.
I think you only need the fully wired ones in combo with an extra room kit....not when the av7000 must switch the mcl2p 
Off course, I might be the exception to the rule here .....(would not be the first time...lol) but that's how my system is working ...

Thanks Steve and thanks CoolDude.  Now I am confused but I'm used o it by now.  I have soem Mk.2 cables hooked up to a pair of pentas so I'll try those and see what happens.  Thanks again