Posts by Dustmaker57 (archived2)
8 total posts8 results
TX2 with loose tonearm
in Imported Content (Unmapped) · May 15, 2020 22:41A correction on this post....the horizontal white bar should be vertical, not laying flat. When that bar is flat, the tone arm is in the down (playing) position So at rest, I believe the bar should be vertical
TX2 with loose tonearm
in Imported Content (Unmapped) · May 15, 2020 22:41A correction on this post....the horizontal white bar should be vertical, not laying flat. When that bar is flat, the tone arm is in the down (playing) position So at rest, I believe the bar should be vertical
TX2 with loose tonearm
in Imported Content (Unmapped) · Apr 29, 2020 04:16To followup on this thread, the horizontal white bar should be laying flat. In the first picture above, the white bar is upright even though the metal rod has not been engaged. The comment above by Martin, is that a smal…
TX2 with loose tonearm
in Imported Content (Unmapped) · Apr 28, 2020 14:13I’m a little late here and not intending on stepping into the conversation, so I am answering from your first picture which is clear. The end of that steel rod, should be tight against the white bar. Follow that bar towa…
tx2 tone arm and platter stuck
in Imported Content (Unmapped) · Apr 24, 2020 22:30Never mind. It started working and the platter no longer locks. On to the other issues
tx2 tone arm and platter stuck
in Imported Content (Unmapped) · Apr 24, 2020 22:30Never mind. It started working and the platter no longer locks. On to the other issues
tx2 tone arm and platter stuck
in Imported Content (Unmapped) · Apr 24, 2020 02:08I meant to say, “can’t find the discussion”
tx2 tone arm and platter stuck
in Imported Content (Unmapped) · Apr 24, 2020 02:06I am a new owner of a TX2, and I have the same issue described here. The platter just locks when I press stop while the motor continues to turn. i know this thread is old but I looked for the small arm issue you mention …