Posts by Sapujapu (archived2)
14 total posts12 results
Beogram CD50 Belt change
in Imported Content (Unmapped) · Mar 2, 2020 20:16Thank you very much Soren, now i got a working CD 50 for my BM 5000.
Type 2323 Beomaster 5000 3v memory battery
in Imported Content (Unmapped) · Feb 25, 2020 13:55Jea static can be a pain, since working on old commodore computers a few years back I always wear a wirts strap.
Type 2323 Beomaster 5000 3v memory battery
in Imported Content (Unmapped) · Feb 25, 2020 10:42[Double Post]
Type 2323 Beomaster 5000 3v memory battery
in Imported Content (Unmapped) · Feb 25, 2020 10:42Thanks for the info, just replaced mine too. Took me less then 15min.
Beocord 5000 goes into standby after 5 seconds
in Imported Content (Unmapped) · Feb 24, 2020 18:43Hey Martin, didn't get your belts yet. I disconnected the tape mechanism and it still shows the same behaviour this let's me believe that the issue lies not in the belts/motor. Unless the processor is that intelligent an…
Beocord 5000 goes into standby after 5 seconds
in Imported Content (Unmapped) · Feb 24, 2020 17:55Hello, i recently got a Beocord 5000 with broken belts and im now trying to get it working again. I replaced the belts and also the blown 10 ohm fusible resistor R20 on the power supply. And it works just fine for 5 seco…
Beocord 5000: Tape Drive spinning and draw not working
in Imported Content (Unmapped) · Feb 20, 2020 16:49Hey Martin, yes i got a flamepoof one.
Beocord 5000: Tape Drive spinning and draw not working
in Imported Content (Unmapped) · Feb 20, 2020 14:22Ok i replaced the resistor and belts and the drawer and deck is working now but i goes back into standby after 10 seconds. I already contacted Martin for some better betls. Any other recommendations what i could check? B…
Beocord 5000: Tape Drive spinning and draw not working
in Imported Content (Unmapped) · Feb 13, 2020 16:54How much Watt should the replacemant have? Ok just looked it up, the wiring diagramm says 1/4W. Is it normaL that the tape motor is spinning in the background? This is my first beocord so i have no clue.
Beocord 5000: Tape Drive spinning and draw not working
in Imported Content (Unmapped) · Feb 13, 2020 16:54R20 is it right? Seems dead
Beocord 5000: Tape Drive spinning and draw not working
in Imported Content (Unmapped) · Feb 13, 2020 16:27Hey Dillen, where is that resistor located in the power supply? Do i need to remove the transformer cover?
Beocord 5000: Tape Drive spinning and draw not working
in Imported Content (Unmapped) · Feb 13, 2020 14:39Hey Guys, so i just got myself a Beocord 5000 (Type 4921), when waking it up from standby the tape drive motor starts spinning and does not stop. I just cleaned and removed all the old belts so the motor cant turn anythi…