B&O 4004 Tone arm

in General Discussion & Questions · Dec 23, 2010 18:50 GMT

Step1 3 in 1 is all I had. I will get some sewing machine oil for the next time. Care to give me the reason for the fuzz? It is not going back. :)

B&O 4004 Tone arm

in General Discussion & Questions · Dec 23, 2010 17:06 GMT

And here's the wire going below the carriage.

B&O 4004 Tone arm

in General Discussion & Questions · Dec 23, 2010 17:04 GMT

Here's the wire from the bottom of the tone arm somewhat frayed.

B&O 4004 Tone arm

in General Discussion & Questions · Dec 23, 2010 17:02 GMT

Here's both springs.

B&O 4004 Tone arm

in General Discussion & Questions · Dec 23, 2010 16:57 GMT

Hello, After a busy summer, I finally got a chance to (try) listen to records on my 4004. Much to my dismay, the carriage would move but the arm not set down on the record. After pleading with the entity whose birthday w…

Beogram 4004 Servo Belt

in General Discussion & Questions · Mar 13, 2010 11:44 GMT

I received the belts Martin sent me earlier this week but did not have a chance to install them until today. The difference between the LP Gear servo belt and Martin's is astounding! And the TT works smooth as silk again…

Beogram Drive Belts

in General Discussion & Questions · Mar 8, 2010 09:36 GMT

I ordered my first set from LP Gear but they were not correct. Martin helped me get the right ones and they were more reasonably priced (I hope they get here soon!).

Beogram 4004 Servo Belt

in General Discussion & Questions · Feb 24, 2010 09:05 GMT

Wonderful board, good info, been reading posts since I acquired a used 4004 last September. Read about the horrors of sending these through the mail and winding up with wood chips and shrapnel so I was lucky that the sel…