Posts by Moritz (archived)
7 total posts6 results
Technical Masterlink Question
in General Discussion & Questions · Oct 30, 2007 09:28Not an expert and not familiar with the LinkConverter ( yet ) but as far as i know almost all ML products can put sound on to the ML but only from one component at a time since there is only one "soundbus" on the ML. Onl…
Beovision 9000 problem - can any anyone please help?
in General Discussion & Questions · Oct 30, 2007 07:48You get this error when there is no communication between TV and ControlCenter ( stand ). If the TV doesn't power up the problem is there.( Red led on top of TV should be on in st-by ) If TV powers up the problem can bee…
CRESTRON CONTROL
in General Discussion & Questions · Oct 29, 2007 05:21Hi There Just bought a used AV9000 and used many hours last week programming Crestron, testing + + +. I only use ir from Crestron, not the B&Oadapter. (learning a beo- remote takes time since there are a lot of different…
MPAV 9000 won't power up
in General Discussion & Questions · Oct 24, 2007 09:17Found the problem. ( partly... ) MasterLink sense pin4 has to bee high on the MPAV. I didn't get the original ML-cable so i'm using an other. Mabe use of the right cable would have solved the problem much earlier. Only p…
MPAV 9000 won't power up
in General Discussion & Questions · Oct 24, 2007 00:36Thank you, "light" and "open" are the only operative functions on my unit too. In testmode i can operate the cd, tape and radio, the I2c bus seems ok and PSU voltages too. So far all seems ok but I don't have the service…
MPAV 9000 won't power up
in General Discussion & Questions · Oct 23, 2007 04:12New to this forum and I'll start with a simple Q. Should the MPAV power up when only power is connected? ( without Masterlink connected, only for testing main functions )