Posts by klesolin
13 total posts9 results
Beosystem 2500: new door belts but still not completely closing, why?
in BeoSystem · Sept 11, 2023 14:36Noted. How do I remove the old glue? I'm not sure what it is, it kinda yellowed. I was thinking about scraping it off with a blade but I'm worried it might peel off the black rectangle that's on the window. Would acetone…
Beosystem 2500: new door belts but still not completely closing, why?
in BeoSystem · Sept 11, 2023 12:07Upon closer inspection, it looks like the bracket fell off the door at some point and was glued back slightly wrong... It fell off again now so I have to figure out how to clean the old glue and which glue to use to put …
Beosystem 2500: new door belts but still not completely closing, why?
in BeoSystem · Sept 9, 2023 08:14So, that worked. But the right window sits a little lower than the left still. They close right, but the top and bottom edges don't align properly. The right door sags a tiny bit. I can push it up, unlike the left and it…
Beosystem 2500: new door belts but still not completely closing, why?
in BeoSystem · Sept 8, 2023 16:40Thank you both, I'll try that!
Beosystem 2500: new door belts but still not completely closing, why?
in BeoSystem · Sept 8, 2023 01:41I've completly overhauled this Beosystem 2500: changed all the belts (tape, CD loader, doors), cleaned, greased, and tested the whole thing, works great. Except the doors!! They seem to open fine as the edge of the glass…
Beosystem 2500: what to replace rotted foam in the speakers with?
in BeoSystem · Sept 3, 2023 09:37I am restoring a Beosystem 2500 and its speakers. I am removing the rotted, old foam but I don't know what to replace it with. Can I buy a replacement kit from B&O direct? Or do I need to buy something else (and where)? …
Beolab Penta: how do you get to the crossover PCBs?
in BeoLab · Sept 1, 2023 17:09Thank you. I had a look, the caps look OK and so do the coils. The speakers sound fine to my ear. Do you mean physically damaged coils? How can they get damaged from within the speaker?
Beolab Penta: how do you get to the crossover PCBs?
in BeoLab · Aug 31, 2023 08:05I see them in the service manual, they're boards 14 and 15. But they don't really tell how to get to them. Is it just a matter of unscrewing the foot and the plastic base and then I can slide them out? I'd like to inspec…
Beovox Penta: trim pieces not holding in place anymore
in BeoVox · Aug 8, 2023 05:07I've just gotten a pair of Beovox Penta for a steal and I have a few questions. As expected, the 8 midranges will need to be refoamed as the original compound is falling apart. Are there any recommendations for a kit wit…