Beogram 8000 or 8002

in BeoGram · Feb 13, 2023 03:09 GMT

I am leaning that way. The sensor arm on the 8002 looks nicer too. The left and right arrows actually do something. Was there an issue with the original ribbed design? I don't notice any performance difference between th…

Beogram 8000 or 8002

in BeoGram · Feb 12, 2023 11:14 GMT

I currently own an 8000 and 8002 in similar condition. Both have gone through the same restoration process. The 8000 now has the 8002 main board and cpu (I wanted the repeat indicator). The 8000 has a MMC20CL and the 800…

Beogram 8002 stops short

in BeoGram · Oct 6, 2022 05:01 GMT

Got it up and running. Circled back to the basics. Checked my solder work. Pulled as much as the old solder my vacuum could. All new solder. Cleaned and checked all mechanicals. Then checked my work and calibration of th…

Beogram 8002 stops short

in BeoGram · Oct 5, 2022 03:57 GMT

No I'm still working on this one. I meant I got a 4002 running from your blog a while ago.

Beogram 8002 stops short

in BeoGram · Oct 4, 2022 04:08 GMT

Very helpful. Your posts got me through a 4002 restoration! I used a camera to determine the emitter was faulty.

Beogram 8002 stops short

in BeoGram · Oct 4, 2022 00:10 GMT

sonavor wrote: Sorry, I didn’t read the previous threads closely. It sounds like you have set the steady-state levels on the scanning buttons where the LDRs measure 620 mV. I would connect an oscilloscope to the sensor s…

Beogram 8002 stops short

in BeoGram · Oct 4, 2022 00:05 GMT

I have replaced the emitter diode on the encoder. I can't find the correct part for the 2 receivers.

Beogram 8002 stops short

in BeoGram · Oct 3, 2022 18:54 GMT

Everything in the control panel has been replaced and adjusted to spec. New bulb and photo sensors went in. It seems like an issue with the rotary encoder. The arm moves for a couple seconds before it stop. I'm going to …

Beogram 8002 stops short

in BeoGram · Oct 3, 2022 18:51 GMT

Die_Bogener wrote: You start a Beogram to play without a record? Nice, you will destroy the MMC if it continues. That’s a safety feature. As you can see there is no cart attached. If a 45 is placed on the platter it does…

Beogram 8002 stops short

in BeoGram · Oct 3, 2022 01:32 GMT

I have made some progress. This table didn't turn on at all when I got it. I replaced all the caps and clean al the mechanicals to get to this point. It spins and locks on speed. I tested with a rpm tool. The carriage mo…