U70 headphones + foam problem

15 replies

Hi,

Iąve just found in my storage U70 headphone and it looks like new but when I took them into my hands I found that the foam need to replaced due to age (black rubber goes off). Any ideas how to cope with this problem?

Max

Dillen wrote:
Even if you should find one that still carries it, it will fall off at first use.

Not always I still have one with the thin "leather" on it and it stays perfectly. 

Leslie wrote:

Dillen wrote:
Even if you should find one that still carries it, it will fall off at first use.

Not always I still have one with the thin "leather" on it and it stays perfectly. 

 

 

 

I have three or four U70s with the black surface still intact. I touched one a couple of years ago and it flaked off
right away so I will not touch the others. I wouldn't expect them to last in use though.
If you have one still intact and holding on, then fine. It may be the last individual from years of production or the
pads may have been replaced back when they were still available but it's fair to say that you would need
more than a fair share of luck to find such a piece, just as much as you would a fresh and complete set of
replacement earpads and I doubt it will last very long with daily use even if you did.
It may not be impossible but telling a Beoworld member, asking for a solution, to just go and find an intact one
would not be a useful option to the OP.

 

Intresting, I was just thinking how to recover my U70's. I Guess atmosphere were they have been plays a big role in if they go to flakes or not. I have CX100 with original foams, no sing of rot yet.

I think I'm going to wash old pads clean for a start.

Think I'm gonna do an excersise on those U70 pads as well (yes, my fourth, without the black leather). The white looks pretty uggly.... 

I agree - if you can find a solution to the problem, I am sure many will be very interested.

My B&O Icons:

BeoCenter-9500.png BeoCenter-9500.png
Beoremote-Beo4.png Beoremote-Beo4.png
Beovox.png Beovox.png
Beovision-11.png Beovision-11.png
Beotime.png Beotime.png
Beosound-Stage.png Beosound-Stage.png
Beosound-Moment.png Beosound-Moment.png
Beosound-5.png Beosound-5.png
Beosound-2.png Beosound-2.png
Beoremote-One.png Beoremote-One.png
Beoplay-Portal.png Beoplay-Portal.png
Beoplay-Earset.png Beoplay-Earset.png
Beomaster.png Beomaster.png
Beolit.png Beolit.png
Beogram-400x.png Beogram-400x.png
Beocenter-2.png Beocenter-2.png

Orava wrote:

Intresting, I was just thinking how to recover my U70's. I Guess atmosphere were they have been plays a big role in if they go to flakes or not. I have CX100 with original foams, no sing of rot yet.

I think I'm going to wash old pads clean for a start.

Leather tend to go bad if not used, if used frequently, like the U70s, just the grease from your skin will keep the the leather fresh and soft, if left in a box or drawer it will dry out, get stiff and start breaking. And as Oreva points out, the ambient where used or stored.

 

Location: Mexico city

Retired
Printing machine technician
Restored various 1960-70 items
Rock and Roll music
Collecting Vinyl
Restored Jukebox Wurlitzer 1050

These are the pnes I photographed for Beocentral - I have boosted the brightness so that you can see the texture of the covering. I confess to never finding the U70s very comfortable and my HD600s outperform them by a huge margin. They do look very good though!

 

My B&O Icons:

BeoCenter-9500.png BeoCenter-9500.png
Beoremote-Beo4.png Beoremote-Beo4.png
Beovox.png Beovox.png
Beovision-11.png Beovision-11.png
Beotime.png Beotime.png
Beosound-Stage.png Beosound-Stage.png
Beosound-Moment.png Beosound-Moment.png
Beosound-5.png Beosound-5.png
Beosound-2.png Beosound-2.png
Beoremote-One.png Beoremote-One.png
Beoplay-Portal.png Beoplay-Portal.png
Beoplay-Earset.png Beoplay-Earset.png
Beomaster.png Beomaster.png
Beolit.png Beolit.png
Beogram-400x.png Beogram-400x.png
Beocenter-2.png Beocenter-2.png
Good morning class. Enough is enough. Tomorrow all of you in my office with you guardians.

Now...... A person asks for an advice and this post becomes a battlefield. Congratulations. You should all be ashamed of your selfs.

Now stop acting like 5 year olds and grow up to your normal age.

In many cases it happens that a sense of humor is not understood and becomes a bad remark.

From my point of view everybody has the right to his own opinion and according to the experience can prove it. I fully respect the knowledge of all of you and frankly speaking everybody has given something positive in the forum.

As explained I also felt very offended by some people in the forum, therefore I just left but this is also not a solution.

I will propose the following:

Shut up all of you, say one I'm sorry as it is Christmas and continue advising.

Dear Martin, I know Leslie for many years now and I can really confirm that he had helped me very much with solutions that B&O techs would just say it's not possible, doesn't exists bla bla bla. Ok. Can be unorthodox in some cases. So what? It works? It works. So why not use it?

On the other hand dear Leslie, I know Martin and have "worked" with him since they very start of Beoworld (not even remember when back in 2000s) and has done a fantastic job preserving the knowledge and passing this through the forum.

You both make a complete technical support to everyone. So please continue like that, helping people, showing examples to all of us and that's all..........

Merry Christmas and Best regards

The Master of the Universe!!!!!
And just for this posts. I really hate the U70s. They are ugly, huge and useless. But ok they sound very nice. :)
or
BeoWorld Gold Membership card
Join BeoWorld

Register to access the forums, reference material, and exclusive member benefits — including our monthly prize draw.

Become a Member

December 2026 Prize Draw

Gold Members Only

As a Gold member you're automatically entered into our exclusive prize draw — your chance to win iconic Bang & Olufsen products. A unique benefit of BeoWorld Gold membership, every draw brings a new opportunity to win something special.