There is a dial string but it's usually OK.
The common fault is the tuning slider breaking off one or two of its tabs at the back. The tabs that grip
the dial string.
If one or two of the original three tabs are still good, you can simply glue the dial string to the remaining
tab(s). Make sure to have the slider aligned according to frequency - tune in to a station with a known frequency by
pulling the string by hand and place the slider accordingly.

Martin

Thanks. Having looked inside, there is no string... so this clearly isn't a new fault. Is the string on a spring with a single turn around the drum?

Yes, and around two small wheels apprx 15cm apart.

This is the same thing from a Beomaster 3000, it's very similar to your Beomaster 4000.
You can actually see glue remains on the string from a previous repair:

Login to view image

Martin

Thanks, the picture made the repair much easier, but unfortunately it stll doesn't change tuning - presumably why the previous owner removed the string.

It's permanently on about 105kHz, the top of the band (mine only shows 104 on the cursor - I also wondered if I could increase the range to 108 with a different resistor?). I presume that the variable resistor has gone open circuit on the wiper arm; it doesn't look like any of the usual rheostats stocked by local suppliers - are they still available?

I agree, it sounds as if a lead or a solder tag has broken off the tuning potentiometer it something broke inside.
I may be able to find some good used parts if you need.
Will it tune correctly if you use the FM presets (small fingerwheels) ?

Martin

Yes, the presets all tune well, so I don't really have to have the main tuning... but it annoys me to have a main cursor which doesn't do anything!

Any thought about extending the tuning range above 104MHz - would adding a small resistor before the rheostat (perhaps on one of the presets?) move the whole range upwards? I realise that the tuning scale numbers would be wrong.

As I have a BM 901 coming, I'm very interested in the above 104 Mhz.

I have now checked the tuning potentiometer solder connections, all looked fine but I 'refreshed' them anyway. The tuning potentiometer shows resistance on my meter, with variation as expected between the centre and end tags as it is turned, so it is therefore behaving properly. Since that left the 0,47mcF electrolytic capacitor between the centre tag and the earth 'bar', I have changed that, too.

Tuning is still 'stuck' at about 105MHz - top of the dial. The small presets still work; as all the tuning buttons are effectively in parallel, individually brought into circuit as required, I suppose that leaves only the switch to check.

Is my logic correct? Have I missed something obvious? Or not so obvious?

All advice gratefully received...

Sounds reasonable.
There are also one or two trimmers (small board mounted potentiometers) on the
long switch PCB, almost right below the large tuning potentiometer pulley.
(They may be accessible from the underside - I don't remember)
One of them could be bad due to oxidation and/or loss of slider tension.
Worth checking.

Martin