Update:

 

Both TV now have the same status.

The one that was not turning on at all has a broken eeprom socket (for eeprom no.2) on the right side which I could fix with a piece of plastic now sitting between the broken side of the socket and the metal framing. It gives enough pressure to make good contact between the socket and the eeprom.

Now the TV starts, the backlight of the screen turns on, but the picture stays black. This is the same as with the other TV set.

So I think it's normal behavior when updating the SW from 7.xx to 30.08a on the eeprom part without updating the corresponding software with the service tool, right ?

For Information: I disconnected the dvb-t tuner from the TV as it will be of no use in my setup, but that also made no difference.

 

Martin

Do you also updated the m2 software in the tv? Thuis has to be done with the dealer

Servicetool. Otherwise it will not work

Thanks for your answer.

M2 update has not been done so far. Before calling the dealer I wanted to check if eeprom update by myself was successful.

After updating another BV7 from SW7.50 to 7.94 I got the typical "snowstorm" on the screen, but updating from SW7.xx to 30.08a shows a different result - the screen stays black, but backlight is on.

Is that ok so far until m2 has been updated ?

 

Martin

 

Ok, will see what will happen if the dealer does the m2 update tomorrow.

Hope that everything is fine after that.

 

Martin