Thank you to our Sponsors
HiThe NL/ML convertor still needs to be the video master and the sources listed on the BeoVision 11 need to be set as video sources and not audio commands.
I´ve set the NL/ML as V.Master. In the view "Sources visible on ML" the ML Audios Sources are greayed out, and the video sources are not. Is that what you mean?
thats correct in this setting. Be sure you have UN-checked the RADIO box in "Experience mapped to NL".
And assign the right source to the right IR command in the tab: "IR Mapping"
Location: Sweden
My B&O Icons:
Did you asign also in your TV menu (not the converter), check it!
EDIT: check on menu > radio must be DTV2
and the radio text must be disappeared within the ML part
Put power off converter, wait a few moments and put it back in. Let it restart...
Above pics are the same as mine, it works over here: (V1, BV3, ML/NL converter, Passive and BL2000) in a ML link
Hiort, do you have something connected to the USB of the NL/ML converter (the 000.000.000@.......... IP address in your setup).
Maybe you should do a reset of the NL/ML converter. Something is going wrong there!
Maybe you should do a reset of the NL/ML converter. Something is going wrong there!
Don't let him loose all settings, just power Off & On will be enough!
I will do a reset. Think BC2 settings are still there.Hiort, do you have something connected to the USB of the NL/ML converter (the 000.000.000@.......... IP address in your setup). Maybe you should do a reset of the NL/ML converter. Something is going wrong there!
Location: Sweden
My B&O Icons:
Location: Sweden
My B&O Icons:
The answer was given earlier but seems to have been overlooked
MasterLink only works when you have a "Current Master" on the ML to supply the voltage/power for ML to function, that used to be your BC2 but now that's gone you are missing that for ML to work
Only audio systems with ML or Video products with ML can act as the Current Master, the only exception is the old BeoLink converter AUX/ML that can also do the job, but without it your masterlink system will not work
Sorry for the bad news, hope this helps to get the problem sorted out for you
So the power on or off had no change to the good. Hior, don't give up hope!
Did you asign also in your TV menu (not the converter), as I asked... check it!
check on TV menu > radio must be DTV2
and the radio text must be disappeared within the ML part
- Can you start the radio on your TV with the command DTV2? Do you hear it playing?
- Have you been trying on the BL2000 or only on BL3500?
Set-up button in small hole aside the light; try a factory reset and reprogramme the BLC
You must be logged in as a BeoWorld member to post replies to forum threads.
Register to access the forums, reference material, and exclusive member benefits — including our monthly prize draw.
Become a Member