You need to add the P-Mute function to the LIST in Beo4. Press LIST and red button simultaneously.  Then choose ADD. Find P-MUTE and select.

Clouding looks different from what you describe. It looks like brighter "clouds" that you may see when you have very dark scenes in a movie.

Hiort wrote:

You need to add the P-Mute function to the LIST in Beo4. Press LIST and red button simultaneously.  Then choose ADD. Find P-MUTE and select.

hmm, that sounds like a plan, only problem there is no P-MUTE to find on the BEO4, odd.

OK, then you have an older version of Beo4 without P.MUTE.

Press AV and then TV (or DTV), should also mute the picture of your BV10-40.

/Räuber

Thats odd...   You cant find it if you scroll down the list when you have activated "ADD"?

Hiort wrote:

Thats odd...   You cant find it if you scroll down the list when you have activated "ADD"?

when I press LIST repeatedly I get: FORMAT STAND SPEAKER P-AND-P RECORD FORMAT...

after activating ADD? (through OK button?) I get AV? LIGHT? CNTROL?AV? ..(through repeatedly pressing LIST

am I missing something somewhere?

As regards the RC, it got delivered yesterday with the 10-40.

While we are at it and with lots of seemingly knowledgable folks around: the panel is somewhat slanted forward: top is 3mm further away from the wall than the bottom, (the wall itself in perpendicular) can this be adjusted?

Other than that: a magnificent piece!

redil wrote:

after activating ADD? (through OK button?) I get AV? LIGHT? CNTROL?AV? ..(through repeatedly pressing LIST

It's under AV?. Just press OK, and add the P.MUTE.

redil wrote:

... the panel is somewhat slanted forward: top is 3mm further away from the wall than the bottom,
(the wall itself in perpendicular) can this be adjusted?

Assuming that you are using a B&O wallbracket type 4667:

- there are 2 plastic adjustment plates to adjust = pre-stress the the bracket
  to avoid vertical misalignment after putting the TV up ...

Read "Supplement for Wall Bracket 4667, Adjustment plate"

Vienna wrote:

redil wrote:

... the panel is somewhat slanted forward: top is 3mm further away from the wall than the bottom,
(the wall itself in perpendicular) can this be adjusted?

Assuming that you are using a B&O wallbracket type 4667:

- there are 2 plastic adjustment plates to adjust = pre-stress the the bracket
  to avoid vertical misalignment after putting the TV up ...

Read "Supplement for Wall Bracket 4667, Adjustment plate"

Thank everyone, together with the pdf documenation I eventually found P.MUTE.

Regarding the adjustment, Vienna would you have a pointer to the above mentioned documenation, seems that it is not out in the open. May be its accessible only to dealers? If possible I would like to do this rather minor adjustment instead of having to get service again.

redil wrote:

Regarding the adjustment, Vienna would you have a pointer to the above mentioned documenation, seems that it is not out in the open. May be its accessible only to dealers? If possible I would like to do this rather minor adjustment instead of having to get service again.

... the 2 plastic parts and mounting/adjustment instructions are supplied with the wall bracket!

- Will make a scan of the doc and post it as a pdf.

- If the original spacers plates got lost, you can use either large spacer-discs or pieces of veneer/cardbord
  (e.g. business cards) of the appropriate thickness between WB and the wall

PS: unfortunately not a minor operation - the TV has to be removed from the bracket and the lower
mounting-screws of the bracket have to be loosened a bit or even unfastened to insert the spacers!