Welcome to BeoWorld!

Discussed a few weeks back here on site ... Sadly, there is no solution. There was some chatter about an attempt at reproducing them but I don't think that got very far -nor do I expect that it will.

Hi, any news on replacement ear pads for form 1 headphones? 

Thank you

Arnaldo

I bought new ones from B&O store, maybe year ago. Aren't they aviable anymore?

Orava wrote:

I bought new ones from B&O store, maybe year ago. Aren't they aviable anymore?

That's what I've been told by my B&O store...

Too bad 🙁. They could keep them on stock, wouldn't cost much to them... I think...

How about cut them from acoustic foam? Kind used as speaker fret?

In my experience, even replacing with the NOS pieces -you suffer the same issue.

I replaced mine. They sat on a shelf for a year unused. I picked them up and the pads crumbled into oblivion.

The only solution is a replacement using different (than original spec) foam.

Do not waste your money on OEM replacements.

Oh, mine are still ok. Maybe yours were wrongly stored?

I changed mine last time 10 years ago and they became dust in my fingers when last week  I picked up the earphones after a couple years of sleep...

I've heard on the grapevine that an original replacement sponge kit has been located, unopened and unused. 

The owner has already spoken to s sponge manufacturing company to see if they might be able to help - so hopefully it may not be too long before a solution is found to this issue.... 😕