Hi Stefan!

Sounds great!!! I have the 7-40 in livingroom and 6-26 in bedroom and all other stuff in a closet about 10-11 meter between the two rooms. I guess I have to connect the 7-40 and 6-26 with a masterlink and airalcable. And then a scart from my harddiscrecorder (Sony) to 7-40 to get the signal through to 6-26. But also a hdmi same way to get the best picture on my 7-40. I the closet I have a junctionbox and hoped to get the signal to Lintronic from there... but can I get it from the scart getting into my harddiscrecorder? What I'm not sure about is if there always will be sending a signal through this scart to the Lintronic?

Sorry about my confusion!

;-) Jes

 I connected SCART Pin 8 (data) and Pin 21 (ground) to IR data input of the -238 box and it works. Tested it with MX 4000 and BV7-40.

Connect your -238 box to Lintronic`s Memory map, and you can see the commands. Works also from linkrooms and in an MCL-system.

I have a Relay 108 board connected to my MCL-system and it works. 

Hope this helps

Stefan

Nice... Then your can control it from a link room. Nice job 🤒

 I connected SCART Pin 8 (data) and Pin 21 (ground) to IR data input of the -238 box and it works. Tested it with MX 4000 and BV7-40.

Connect your -238 box to Lintronic`s Memory map, and you can see the commands. Works also from linkrooms and in an MCL-system.

I have a Relay 108 board connected to my MCL-system and it works. 

Hope this helps

Stefan

OK, thanks a lot Stefan

/Frank

Fantastic Stefan!

I'll give it a try... Do you know if I can take the signal at the end where I have the harddiscrecorder (10 meter from my 7-40), because I would like to have my Lintronic 238 at the same place as my other stuff it's going to control. Then I don't have to make my TT-IR-ET03 Infrared Emitter longer.

;-) Jes