frankmj:

What if you bypass the RF amplifier and press v.tape in the link room. Does the Video start?

/Frank

You must use RF amp. It´s only picture that goes there. All commands goes through ML 

I know, it was just to test the ML-connection, if that works, he has to look at the amp. and the connections to RF.

/Frank

It makes no difference. There is no connection between mx4000 and the BS3. If I hold down the red stop button in one room for 3-5 sec. it is only the TV in that room that turns off, normally both TV would turn off.

It also makes no difference if I disconnect the Beolink Video, only reaction is "snow" on the screen.

Well I think that I will get a B&o technician to take a look at the problem.

Thanks very much for your good suggestions.

Karcenty

I had a similar problem with an beolink 1611. Solution was to first plug the mx to the mains , wait a few secondsand than the beolink to the mains.

Have also been tried with no luck.

Karcenty 

Have you checked the LINK frequens on the BeoSystem 3 should be 599?

/Mads 

Yes, and I have tried different freq. as well.

Karcenty 

I am not sure with the MX, but when I got my used BV1 with ML socket and the Beolink did not work I realized that the BV1 just comes with the ML socket but not with the modul. AfterI got a modul from my dealer and pluged it in it worked....

Karsten 

Have you tried to connect a beomaster (sound) to the masterlink plug in the linkroom?

this way you can test the masterlink connection. choose cd in the livingroom and see if the cdplayer is reacting

That is a very expensive test ;-) I don't have any beosound system.

Karcenty