Beolab 4000 switching on from stand-by problems (works only powering it off for 5/10 secs)

2 replies
AL
Offline
alfio
Bronze
Posted August 16, 2017 at 15:50 GMT
#2091893

Dear All

I have seen a similar thread on forum some time ago, but it did not match the behaviour

problem for my BEOLAB 4000 - S/N 13063449 bought on bay some years ago and used once twice a year as it is in my summer apartment.

I checked the cables extensively and initially I thought they were the responsible , instead finally I was able to reproduce the behavior.

I I switched off the system and leave the BEOLAB in standby for some time it does not switch on. However if I disconnect the power (from the power cable) and plug it in again it works immediately.

If I switch on/off the system in few seconds it works without any problems.

I start thinking about capacitors, but I would appreciate your suggestion and maybe a similar experience.

AK
Offline
akoitidis
Bronze
Posted September 13, 2021 at 11:37 GMT
#2091894

Hello all I am experiencing the same issue with alfio, any suggestions?

or
BeoWorld Gold Membership card
Join BeoWorld

Register to access the forums, reference material, and exclusive member benefits — including our monthly prize draw.

Become a Member

December 2026 Prize Draw

Gold Members Only

As a Gold member you're automatically entered into our exclusive prize draw — your chance to win iconic Bang & Olufsen products. A unique benefit of BeoWorld Gold membership, every draw brings a new opportunity to win something special.

View Prize Go For Gold