Thank you to our Sponsors
Hi,
another question about my new Avant.
I might be able to obtain a MPAV 9000, or Master Panel AV9000. If my Avant had a surround unit attached to it, is it possible to connect that MPAV 9000 to my Avant? If so, do I need a Master Link cable or something which goes to some input sockets near Power Link sockets?
And if the above is OK, can I control the whole set with Beo4, or do I need the Beolink 5000?
(I'm not near the Avant now, so can't check the sockets)
Thanks again,
Pekka
I think the short answer is no, the software or drivers required to operate the MP are built into the AV9000.
Someone will confirm for sure.
Sorry for not.
it works, but no Display and settings....
Only LOAD and LIGHT give a response.
Ulf
OK, so Beo4 won't work?
But can I use the MPAV9000 directly, from buttons and get the sound out from Avant?
Pekka
No,
Beo4 works but no Buttons and no Display at the MPAV
Sound for all Sources RADIO,CD and TAPE works.
Ulf
Ulf, I'm a bit confused now, maybe, because I've never seen the MPAV in function.
So, would it be a good idea to buy the thing to go with Avant?
In the Avant manual there is a device connected to Avant, which looks like MPAV, but might be some other device. Is there a better option?
How about adding pair of Beolab 4000 into setup?
I have to admit, that I've dropped off a bit from B&O development. My experience and love to B&O dates to my trustworthy Beomaster 1900-2 and Beovision 601 era.
Pekka
BEOSOUND OUVERTURE
Craig🙂
did you manage to hock up the mpav9000 to your avant?
if so how???
thx
/m
You must be logged in as a BeoWorld member to post replies to forum threads.
Register to access the forums, reference material, and exclusive member benefits — including our monthly prize draw.
Become a Member