Good morning and welcome to Beoworld!

If it has a LIST button then it is almost certainly a Beo4.  I don't think that early versions (pre SW 4.4) had the MOVE function.  But if it does, here's how to use it:

Login to view image

If it doesn't have the MOVE function, then you could delete all the functions from LIST and then re-add them in the order you require.

If the remote is a 'hotel' version then it may have restricted functionality and not offer many of the functions that you mention.  These usually have a slightly different button layout and a separate MUTE button.

If you are not using the TV function, there is a way to use the TV button to select the AV2 SCART input - basically by going to the TV's SETUP then SOCKETS menu and choosing 'Decoder' as the  AV2 input.  Then go to the TUNING menu, choose TV channel 1 and change the Decoder setting to 'On'.  Pressing TV will then choose the AV2 input.

 

 

Thanks a ton! I will definitively test out the decoder trick and let you know. I can however confirm that adding functions in the reverse order does not work. It lists them alphabetically nomatter in which order I put them in.

Thanks!

Hey again!

I managed to change AV 2 to Decoder. Very easily accessible  via the Menu button. But I can't figure out (even with the TVs manual) how to enable decoder?

What I tried was: 1. TV (button on remote), 2. LIST (button on remote), 3. V. SETUP shows on remove - i push Go. 4. TUNE shows on remove i Push Go.

Then I get this:

Login to view image

Not sure if I'm at the right place at all?  Can't figure out how to change Dec to on anywho.

Any help is deeply appreciated. Thanks ??

You should be able to get to the tuning menu by using Menu button (on remote) then choose Setup (on TV screen) then choose Tuning (on TV screen).  Then you should be able to use the remote arrow to move to the right and change Dec to On.

link

You should be able to get to the tuning menu by using Menu button (on remote) then choose Setup (on TV screen) then choose Tuning (on TV screen). Then you should be able to use the remote arrow to move to the right and change Dec to On.

Well. Then I ask how? All I see once going into Setup Via Menu on the remot is this (sorry for the reflections in the TV):

Login to view image

I think you have an older version of the TV that was actually introduced when the default remote was a Beolink1000 (without a screen).  I am guessing a bit here but give this a go:

Firstly I think that you need to add TURN and STORE to the LIST function of the Beo4 remote (using the ADD function of the remote menu I describe earlier).

Then turn the TV on by pressing TV.

Press GO (the cue TUNE appears on the screen).

Use the number pad to key in 0 7 5 (or any random frequency)

Use the Beo4's LIST button to select TURN, and then press GO several times until 'dec on' is shown on the tune screen of the TV.

Use the LIST button to select STORE, and press GO.

Press the number 1 - to store the TV preset as 1.

Use the LIST button to select STORE and press GO again.

I just PM:ed you ??