I recently purchased a set of Beolab 4000’s off ebay for parts as my black ones are beginning to get a bit flakey - but that might actually be the sonos connect they are connected to is a bit flakey.
Anyway they arrived looking a bit worse for wear, but are mk II’s and in good operational condition.
The cloth needs re-doing as they all do. I’m thinking of going a bit more herringbone or very tightly textured on that.
The problem this post is actually about is the paint. Its pretty scratched up, and dinged in a few spots. How do I repaint it? I have an airbrush to use on my 3d prints, but have not done aluminum. If I remember correctly, aluminium doesn’t like to be painted.
Any tips and tricks?
Anyway they arrived looking a bit worse for wear, but are mk II’s and in good operational condition.
The cloth needs re-doing as they all do. I’m thinking of going a bit more herringbone or very tightly textured on that.
The problem this post is actually about is the paint. Its pretty scratched up, and dinged in a few spots. How do I repaint it? I have an airbrush to use on my 3d prints, but have not done aluminum. If I remember correctly, aluminium doesn’t like to be painted.
Any tips and tricks?
